Reading Timers

GCBASIC has the following macros to read a specific timer value. They are: 

    Timer0
    Timer1
    Timer2
    Timer3
    Timer4
    Timer5
    Timer6
    Timer7
    Timer8
    Timer10
    Timer12

Note that these macros should only be used to read the timer value. To write the timer value, settimer should be used.

Not all of these functions are available on all microcontrollers. For example, if a microcontrollers has three timers, then typically only Timer0, Timer1 and Timer2 will be available.

Please refer to the datasheet for your microcontroller to determine the supported timer numbers, and if a specific timer is 8-bit or 16-bit.

Prev  Up  Next
  Home